Worksaver LRHD-6 Spezifikationen PDF herunterladen (Seite 3)

0000WS65:99900663:

-READ FIRST-

SAFETY PRECAUTIONS

19971010

Read and understand the IMT Operator’s Crane

Safety Manual before operation of the crane.

DO NOT exceed crane capacity.

Before attempting full capacity lifts, practice with

light loads to familiarize yourself with crane

operation and controls. Also, observe tilt and

effects on the carrier vehicle’s body during

loading.

Remove the remote control cable from the

crane when the crane is left unattended, even

for short time periods.

The remote control cable must be kept away

from the crane to avoid entanglement. Be

certain never to allow the cable to be crushed

by any outrigger or crimped between anything.

DO NOT use winch when crane is in the stored

position.

When winding cable onto the winch, apply

tension to the cable to keep it straight.

DO NOT wrap wire rope around the load. Use

chains or hooks designed for the job.

Continuous use of the crane winch should be

avoided to prevent overheating of the electric

motor.

Check the crane hook for cracks and distortion,

and safety latch for function, prior to work each

day.

The safety latch of the hook must be closed

before lifting a load.

A heavy-duty battery of 85 ampheres or more is

recommended.

The vehicle must be on a level surface for crane

operation.

Raise load no higher than required to perform

the lift.

Lubricate as required - regularly.

The vehicle’s emergency brake must be set

prior to crane operation.

Load ratings are based on crane capacity, not

unit stability.

NEVER operate the crane near electrically

charged power lines or other sources of

electricity.

The path of the crane must be clear of all

personnel and obstructions.

DO NOT permit cable to be totally unwrapped

from drum. There should be no less than 3

wraps of cable on the drum during operation.

DO NOT weld, modify, or use unauthorized

parts. This can result in crane failure, causing

serious injury or death.

ALWAYS store the outriggers and crane

properly before moving the carrier vehicle.

DO NOT permit unecessary objects to be in the

vicinity of the crane during operation.

The carrier vehicle must meet minimum chassis

specifications but these specifications do not

guarantee unit stability.

The crane must be installed per IMT

specifications. Consult your local distributor or

IMT for any required information.

Outriggers must be used to stabilize the vehicle

whenever the crane is in use.

Outriggers must be positioned correctly on a

firm surface.

Read and familiarize yourself with the

IMT OPERATOR’S CRANE SAFETY MANUAL

before operating or performing any

maintenance on your crane.

1 2 3 4 5 6 7 8 ... 31 32

Kommentare zu diesen Handbüchern

Keine Kommentare