Worksaver LRHD-6 Spezifikationen PDF herunterladen (Seite 16)

0000WS65:99900663: 4-219921030

By pressing the control switch in the UP

position, lift the load slightly off the ground to

test the load and effect on the outriggers and

vehicle. If there are no indications of problems,

the load can be lifted to the desired height by

continuing to press UP. When the load is at the

desired height, swing the crane slowly over the

desired position.

To lower the load, press the switch DOWN,

making certain there are no obstructions under

the load. Release tension on the hook/sling and

remove the sling from the hook, being careful

not to let it swing out of control.

4-5. STORING THE CRANE

Before leaving the job site, it is necessary to

store the crane. Retract the extension boom by

removing the pin in the lower boom and

positioning the extension boom in its fully

retracted position. Insert the locking pin.

On short base models, the boom tip should be

lowered to the deck and secured in that position.

Tall masts provide a pin hole for storage of the

boom at a -90° position. Remove the boom

angle locking pin and gently lower the boom to a

verticle position. Insert the pin as shown in

Figure D-4.

Attach the hook to the hook hanger bracket as

shown in Figure D-3. Be certain the winch

cable is drawn up firmly and that all loose

objects are stored before driving the carrier

vehicle.

Disconnect the remote control handle cable and

store in the truck cab or other suitable, secure

location.

WARNING

NEVER DRIVE THE VEHICLE UNLESS THE CRANE

IS IN THE STORED POSITION AND SECURED

PROPERLY.

Figure D-1. HOOK SAFETY LATCH

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 31 32

Keine Kommentare

Worksaver LRHD-6 Spezifikationen Seite 16