Worksaver LRHD-6 Spezifikationen PDF herunterladen (Seite 13)

0000WS65:99900663: 3-119930211

3-1. GENERAL

This section provides installation instructions for

the IMT WorkSaver™ Crane. See Figure E-9

for specific winch remote control wiring for

cranes with manual swing and Figure E-14 for

those with power swing.

3-2. INSTALLATION

The mounting space required for the crane base

is 10" x 10" (25.4 x 25.4cm) with a square bolt

hole pattern measuring 8" x 8" (20.3 x 20.3cm).

Before determining the location for mounting,

keep in mind that the 5' version crane has a

horizontal reach from centerline of rotation of

62" (1.57m) and the 7' version has a reach of

85" (2.16m). Also important is that the crane

has a 346° (6.04 rad) rotation capability.

Using the holes in the base as a pattern, mark

the location of the four mounting holes as well

as the inside electrical access hole. Drill 11/16"

diameter holes at these five (5) locations. See

Figure C-1.

CAUTION

BEFORE DRILLING MOUNTING HOLES, CHECK

BELOW THE MOUNTING SURFACE FOR ANY

OBSTRUCTIONS, FUEL LINES, EXHAUST OR

ELECTRICAL COMPONENTS.

Locate the base with the rotation stop positioned

for your particular application which is normally

away from the most used working position.

Secure the base to the mounting surface using

four (4) 5/8-11, hex head, grade 5, cap screws;

eight (8) 5/8" flat washers and four (4) 5/8-11

self-locking, hex nuts. See Figure C-2.

After securing the base in position, feed the two

wires from the end of the mast through the

electrical access hole. Place the mast

assembly into the base, being careful not to

pinch the wires.

Once the crane is in place, run the positive feed

wire, with circuit breakers, along the truck

frame and connect to the starter side of the

starter solenoid. Secure this wire to the truck

frame using cable clamps at approximately 18"

(45cm) intervals. The negative lead wire must

be connected to a good ground on the truck

frame. Prepare the ground location by sanding

all paint or rust down to bare metal for maximum

ground contact. Secure this wire to the truck

frame using cable clamps at 18" (45cm)

intervals.

Figure C-1. MOUNTING DIMENSIONS Figure C-2. MOUNTING HARDWARE

Section 3. INSTALLATION

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 31 32

Kommentare zu diesen Handbüchern

Keine Kommentare

Worksaver LRHD-6 Spezifikationen Seite 13

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Nein Worksaver LRHD-6